Quick Answer: How To Remove Fence Post With Car Jack?

How do you remove old fence posts from concrete?

How to Remove Broken Fence Posts Set in Concrete?

  1. Method 1) Break Up Concrete Footing. Step 1: Remove Old Wooden Post. Step 2: Dig around the perimeter of the posthole.
  2. Method 2) Dig and Lever the Footing. Step 1: Dig around Posthole perimeter.
  3. Method 3) Eye-Bolt Removal. Step 1: Drill Pilot Hole into Post.

How do I remove a post from the ground?

The trick to removing a fence post is to apply force upward, so that you’re not fighting the strength of the earth on either side of the buried post. This can be done with a jack or machinery, or with a lever and some elbow grease. One of the best post-pulling techniques comes from Family Handyman reader Mike Barnes.

How do you straighten a fence post without removing it?

The Fix-A-Fence Solution

  1. Step 1 – Prepare the Site.
  2. Step 2 – Prepare the Fix-a-Fence Kit.
  3. Step 3 – Position the Bracket in the Hole.
  4. Step 4 – Mix a 60lb Bag of Concrete.
  5. Step 5 – Fill the Hole with Concrete.
  6. Step 6 – Take a Break While the Concrete Cures.
  7. Step 7 – Reposition the Fence Post and Attach the Bracket.

How do you remove an aluminum fence post in concrete?

The Rebar Method

  1. Drill a ½-inch wide hole through the post you’d like to remove.
  2. Insert a piece of ⅜-inch rebar through the hole.
  3. Hook a chain around both ends of the rebar.
  4. Attach the chain to a long piece of 4×4 lumber.
  5. Using a cinder block as a fulcrum, pry the post out of the ground using the 4×4 as a lever.
You might be interested:  FAQ: How To Make Concrete Fence?

Can you reuse fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

Should fence posts be set in concrete?

Setting Fence Posts in Concrete Concrete is the most secure material for setting fence posts, especially if you have sandy soil. Gravel may be okay with dense, clay-heavy soil, but in looser soil, concrete is the only thing that will truly keep your fence posts stuck in place.

How deep should a fence post be?

Rule of Thumb Hole depth = put approximately 1/3 of the post in the hole. A 2m (6 foot) post should have up to 600mm (2 foot) in the ground.

Leave a Reply

Your email address will not be published. Required fields are marked *