How To Remove Concrete Fence Post?

How do you remove concrete footings?

Steps in Removing Concrete Deck Footings Using a spade shovel manually excavate around the footing at least 3/4 the way around and at least 2/3rds of the length of the footing. Dig until you see the footing wiggle a bit. The more you dig the easier the footing will come out.

Can you remove a post from concrete?

Dig the Post Out by Hand The most common way to get stubborn fence posts out of the ground is simply to dig the earth out from around the concrete base. By digging slightly deeper than the base of the concrete, you can then tip the post into the hole and lift it out.

How do you remove an aluminum fence post in concrete?

The Rebar Method

  1. Drill a ½-inch wide hole through the post you’d like to remove.
  2. Insert a piece of ⅜-inch rebar through the hole.
  3. Hook a chain around both ends of the rebar.
  4. Attach the chain to a long piece of 4×4 lumber.
  5. Using a cinder block as a fulcrum, pry the post out of the ground using the 4×4 as a lever.

Can you reuse fence posts with concrete?

Pulling up an existing fence post to reuse can be quite a task. Posts with concrete at the base are the most difficult to remove and reuse because the concrete base is larger than the post, which makes pulling it up through the ground much harder.

You might be interested:  Question: How To Whitewash A Fence?

How do you straighten a concrete fence post without removing it?

The Fix-A-Fence Solution

  1. Step 1 – Prepare the Site.
  2. Step 2 – Prepare the Fix-a-Fence Kit.
  3. Step 3 – Position the Bracket in the Hole.
  4. Step 4 – Mix a 60lb Bag of Concrete.
  5. Step 5 – Fill the Hole with Concrete.
  6. Step 6 – Take a Break While the Concrete Cures.
  7. Step 7 – Reposition the Fence Post and Attach the Bracket.

How do you replace a concrete fence post?

Save yourself both time AND money by reading everything you need to know to replace a fence post without removing the concrete below!

  1. Take Down the Fence.
  2. Remove the Main Post.
  3. Remove any Remaining Pieces and Clear the Foundation.
  4. Replace the Post.
  5. Fill the Hole.
  6. Re-Attach the Fence.
  7. Removing Concrete and the Post.

How do I remove an existing fence?

There are a couple ways to strip down your fence to its posts. You can simply take an electric saw and saw the fence material along the post. However, you can also dismantle your fence board by board. To do this, you’ll need to use a hammer to bang the board in toward the rail so that some of the nails is sticking out.

Leave a Reply

Your email address will not be published. Required fields are marked *